Ethernet Cfm Enable (Interface) - Alaxala AX3640S Software Manual

ethernet cfm enable (interface)

When
no ethernet cfm enable
or the applicable port channel stops.
Syntax
To set information:
no ethernet cfm enable
To delete information:
ethernet cfm enable
Input mode
(config-if)
Parameters
None
Default behavior
CFM PDUs can be received.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. This command cannot be set for an Ethernet interface that is set for a channel group. Also, an
Ethernet interface set by using this command cannot be set for a channel group. Set this
command for the port channel interface to which the applicable Ethernet interface belongs.
Related commands
None
is set, CFM PDU transmission processing on the applicable port
33. CFM
717