Sflow Destination - Alaxala AX3640S Software Manual

36. sFlow Statistics

sflow destination

Specifies the IP address of the collector, which is the destination for sFlow packets.
Syntax
To set information:
sflow destination { <ip address> | <ipv6 address> } [<udp port>]
To delete information:
no sflow destination { <ip address> | <ipv6 address> } [<udp port>]
Input mode
(config)
Parameters
{ <ip address> | <ipv6 address> }
Specifies the IP address of the collector, which is the destination for sFlow packets. A
maximum of four sets of the IP address and UDP port can be specified.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
Specify IP addresses in IPv4 or IPv6 format.
<udp port>
Specifies the UDP port number of the collector, which is the destination for sFlow packets.
1. Default value when this parameter is omitted:
6343
2. Range of values:
1 to 65535
Default behavior
None
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. This parameter cannot be changed. First delete the parameter, and then add it again.
2. You can set multiple UDP port numbers for an IP address.
3. The broadcast address, multicast address, and link-local address cannot be set for the IPv4 and
IPv6 addresses of the collector.
Related commands
None
780