Radius-Server Host - Alaxala AX3640S Software Manual

radius-server host

Configures the RADIUS server used for authentication, authorization, and accounting purposes.
Syntax
To set or change information:
radius-server host {<ipv4 address> | <ipv6 address> [interface vlan <vlan id>] | <host
name>} [auth-port <port>] [acct-port <port>] [timeout <seconds>] [retransmit <retries>]
[key <string>] [{auth-only | acct-only}]
To delete information:
no radius-server host {<ipv4 address> | <ipv6 address> [interface vlan <vlan id>] | <host
name>}
Input mode
(config)
Parameters
{<ipv4 address> | <ipv6 address> [interface vlan <vlan id>] | <host name>}
<ipv4 address>
Specifies the IPv4 address of the RADIUS server in dot notation.
<ipv6 address> [interface vlan <vlan id>]
Specifies the IPv6 address of the RADIUS server in colon notation.
Specify the
• interface vlan <vlan id>
<host name>
Specifies the host name of the RADIUS server with 64 or fewer characters.
For details about the characters that can be specified, see Specifiable values for
parameters.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
An IPv4 address, an IPv6 address, or a host name can be specified.
When an IPv6 link-local address is specified, specify the interface at the same time.
key <string>
Specifies the RADIUS key used for encryption or for authentication of communication with
the RADIUS server. The same RADIUS key must be set for the client and the RADIUS server.
1. Default value when this parameter is omitted:
The RADIUS key set by using
server is disabled.
2. Range of values:
Enclose a character string of no more than 64 characters in double quotation marks (").
Specifiable characters are alphanumeric characters and special characters. To enter a
parameter only when a link-local address is specified.
interface
For <vlan id>, specify the VLAN ID set by the
4. Login Security and RADIUS or TACACS+
interface vlan
is used. If no key is set, the RADIUS
radius-server key
command.
51