link debounce
Sets the link-down detection time after a link failure is detected until the actual link-down occurs.
When a large value is set, temporary link-downs will not be detected, thereby preventing instability
of the link.
Syntax
To set or change information:
link debounce [time <mili seconds>]
To delete information:
no link debounce
Input mode
(config-if)
Parameters
time <mili seconds>
Sets the debounce timer value in milliseconds.
1.
Default value when this parameter is omitted:
3000 milliseconds
2.
Range of values:
Multiples of 100 from 0 to 10000
Default behavior
2000 milliseconds is set.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1.
If the link is stable even when a link-down detection timer is not set, you do not need to set
one.
2.
If a value smaller than the default value (2000 milliseconds) is set for 10BASE-T,
100BASE-TX, or 1000BASE-T, the link might become unstable.
Related commands
None
9. Ethernet
121