Jungheinrich DFG 320 Operating Instructions Manual page 96

Adding engine oil
– Add fresh engine oil through the filler
port (2)
consumables table.
Capacity: 8,0 l
Check the engine oil level with the
dipstick (1) and adjust as necessary.
Screw the lid backon.
– Fully insert the dipstick (1).
M
After changing the oil and the oil filter,
note the engine oil pressure indicator (9)
when you run the engine again and
check the oil drain plug and oil filter are
sealed.
Checking the V belt tension
– Insert the V belt between the fan V belt
pulley and the generator V belt pulley
using a force of 45 N.
It should be possible to insert the V belt
after approx. 10 mm.
Adjusting the V belt tension
– Undo the screws (10) and pull the AC
generator
prescribed V belt tension. Re-tighten
the screws.
– Check the V belt tension again and
repeat the adjustment if necessary.
in accordance with
until you reach
the
9
the
10
F 17