Jungheinrich DFG 320 Operating Instructions Manual page 99

Replacing the engine oil filter
– Undo the oil filter (20) with a filter
wrench and manually unscrew it.
F
Collect any emerging oil and dispose of
the oil and oil filter in accordance with
environmental regulations.
– Thoroughly clean the raised faces of
the oil filter flange.
– Apply a thin layer of fresh engine oil to
the seal of the new oil filter.
– Hand-tighten the oil filter.
Adding engine oil
– Add fresh engine oil through the filler port in accordance with the consumables
table (see Section 9.1).
Capacity: 4,0 l
– Check the engine oil level with the
dipstick (19) and adjust as necessary..
– Screw the lid back on.
– Insert the dipstick back fully.
M
After changing the oil and the oil filter,
note the engine oil pressure indicator
(18) when running the engine again and
check the oil drain plug and oil filter are
sealed.
F 20
18