Jungheinrich DFG 320 Operating Instructions Manual page 95

Replacing the engine oil and engine oil filter
M
Only change the engine oil when the engine is at operating temperature and the truck
is horizontal. Always replace the engine oil and engine oil filter together.
Draining the engine oil
– Unscrew the (2) lid.
– Thoroughly clean the oil drain plug (4)
and around the drain hole.
– Unscrew the oil drain plug and drain
the oil into a suitable container.
F
Risk of scalding through hot oil.
– Screw in the oil drain plug with a new
seal.
F
Dispose of used oil in accordance with
environmental regulations.
Replacing the engine oil filter
– Undo the hose clamp (10) from the
hose (9)-
– Pull off the hose.
– Undo the air filter attachment (11) and
place the air filter to one side.
– Undo the oil filter (3) with a filter
wrench and manually unscrew it.
F
Collect any emerging oil and dispose of
the oil and oil filter in accordance with
environmental regulations.
– Thoroughly clean the raised faces of
the oil filter flange.
– Apply a thin layer of fresh engine oil to
the seal of the new oil filter.
– Hand-tighten the oil filter.
– Fit the air filter, insert the hoses and
tighten with hose clamps.
F 16
2
4 3