Setting The User Bit - Canon XF705 Instruction Manual

Setting the User Bit

The user bit display can be selected from the date or the time of recording, or an identification code consisting of
8 characters in the hexadecimal system. There are sixteen possible characters: the numbers 0 to 9 and the
letters A to F.
The user bit is recorded with clips and can be output from the TIME CODE terminal, SDI terminal or HDMI OUT
terminal. It can be used freely to categorize and manage recordings or to keep additional information about
them.
Operating modes:
Setting an Hexadecimal Code
1 Open the user bit setting screen.
> [B # System Setup] > [User Bit Type] > [Setting] > [Change]
• The user bit setting screen appears with an orange selection frame on the leftmost character.
• To reset the user bit to [00 00 00 00], select [Reset] instead.
2 Push the joystick up/down to select the first character and press SET to move to the next.
• Change the rest of the characters in the same way.
• Press the CANCEL button to return to the previous screen without setting the user bit.
3 Select [Set] and press SET.
Using the Date or Time
1 Select [User Bit Type].
> [B # System Setup] > [User Bit Type]
2 Select [Date] or [Time] and then press SET.
Setting the User Bit
91