Setting The User Bit - Canon XC15 Instruction Manual

Setting the User Bit

Setting the User Bit
The user bit display can be selected from the date or the time of recording, or an identification code consisting of
8 characters in the hexadecimal system. There are sixteen possible characters: the numbers 0 to 9 and the
86
letters A to F.
In addition to being recorded with clips, the user bit information can be output along with the video signal output
from the HDMI OUT terminal.
Operating modes:
1 Press the MENU button.
2 Open the [User Bit Type] submenu.
[3 Recording Setup] > [2] > [User Bit Type]
3 Select the desired option.
• Select [ Setting] to set your own identification code, [
to use the time as user bit, or [
bit.
• If you selected [
to perform the rest of the procedure. If you selected [
continue the procedure to set the identification code.
4 Touch [Í] or [Î] to set the first character and then touch the next field to set the next character.
• Change the rest of the characters in the same way.
• Touch [Cancel] to close the screen without setting the user bit.
5 Touch [OK] and then touch [X].
• The user bit is output from the HDMI OUT terminal in the selected type.
Table of Contents
Date] to use the date as the user
Time] or [ Date], touch [X]. You do not need
Time]
Setting],
Menus
[3 Recording Setup]
[2]
[User Bit Type]
[ Setting]
Index