Canon XF705 Instruction Manual page 205

Changing between recording (
- When the SD card contains a large number of clips, some operations may take longer than usual. Save your clips
(A 151) and initialize the card (A 35). Alternatively, replace the card.
The camcorder cannot record to the SD card properly.
- This may occur as recordings are made and deleted over time. Save your clips (A 151) and initialize the card (A 35).
After using the camcorder for a long time, it becomes hot.
- The camcorder may become hot after using it continuously for long periods of time; this is not a malfunction. If the
camcorder becomes unusually hot or it becomes hot after using it only for a short while, it may indicate a problem with
the camcorder. Consult a Canon Service Center.
Playback
Cannot delete a clip.
- The clip may have an $ mark. Remove the $ mark (A 139).
- The LOCK switch on the SD card is set to prevent accidental erasure. Change the position of the LOCK switch.
Deleting clips takes longer than usual.
- When the SD card contains a large number of clips, some operations may take longer than usual. Save your clips
(A 151) and initialize the card (A 35).
Cannot copy clips.
- There is not enough available space on the destination card or the card already contains the maximum number of clips
(999 clips). Delete some clips (
Cannot delete a photo.
- The LOCK switch on the SD card is set to prevent accidental erasure. Change the position of the LOCK switch.
- Photos that were protected using other devices cannot be deleted with the camcorder.
Indicators and Onscreen Displays
appears in red on the screen.
- The battery pack is exhausted. Replace or charge the battery pack.
í
appears on the screen.
- The camcorder cannot communicate with the battery pack attached so the remaining battery time cannot be
displayed.
The tally lamp does not illuminate.
> [$ System Setup] > [LED] > [Tally Lamp (Front)] or [Tally Lamp (Rear)] to [On].
- Set
The tally lamp flashes quickly.
- The battery pack is exhausted. Replace or charge the battery pack.
- There is not enough available space on the SD card. Delete some clips (A 140) to free some space or replace the
selected card.
- A system error has occurred. Turn the camcorder off and then on again. If this does not solve the problem, consult a
Canon Service Center.
The tally lamp flashes slowly.
- The combined available space on both cards is low. Replace the card that is not being recorded onto.
/ appears in red on the screen.
- A card error occurred. Remove and reinsert the card. If the display does not change back to normal, save your
recordings (A 151) and initialize the card (A 35).
6/7 (in red) and [END] appear on the screen.
- The SD card is full. Use a different card or delete some clips (A 140) to free some space on the card.
Even after stopping recording, the access indicator stays illuminated in red.
- The clip is being recorded on the card. This is not a malfunction.
b
appears in yellow on the screen.
- The camcorder's internal temperature has reached a predetermined level. You can continue using the camcorder.
Ü
REC) and record standby (STBY) takes longer than usual.
A
140) to free some space or replace the card.
(4 flashes per second)
(1 flash per second)
Troubleshooting
205