Recording - Canon XF705 Instruction Manual

Recording Video

Recording

42
1 Press and hold the button on the Q switch and set the switch to ON.
• The camcorder turns on in
• The access indicators of card slots with a card inserted will illuminate momentarily in red. Then, the access
indicator of the card selected for recording will change to green.
2 Press the REC button to begin recording.
• Recording starts. The tally lamps illuminate and the recording indicator [ÜREC] appears at the top of the
screen.
• You can use the REC button on the grip or the one on the handle.
• You can also perform this function remotely using Browser Remote on a connected network device (A 162,
167).
• When you use the supplied wireless controller, press the START/STOP button and the record enable button
simultaneously.
3 Press the REC button to stop recording.
• The clip is recorded and the camcorder enters record standby mode. The tally lamps will also go out.
IMPORTANT
• Observe the following precautions while an access indicator is illuminated in red. Failure to do so may result in
permanent data loss.
- Do not open the card slot cover of the card being accessed and do not remove the card.
- Do not disconnect the power source or turn off the camcorder.
• Be sure to save your recordings regularly (A 151), especially after making important recordings. Canon shall
not be liable for any loss or corruption of data.
NOTES NOTES
• The REC button on the handle has a lock lever to prevent accidental operation. Set the lock lever to C to
prevent a recording from starting/stopping inadvertently or if you do not plan to use this REC button. Return
the lever to its previous position to enable use of the REC button again.
• You can use the review function (A 112) to play back part or all of the last clip recorded without having to
switch to
• If you set an assignable button to [Add $ Mark] or [Add % Mark] (A 117), you can press the button to add
an $ mark or % mark to the last clip recorded.
mode and enters record standby mode.
mode.
Tally lamps
Card access indicators