Using The Optional Rc-V100 Remote Controller - Canon XF705 Instruction Manual

Using the Optional RC-V100 Remote Controller

You can connect the optional RC-V100 Remote Controller to the camcorder's REMOTE A terminal or REMOTE
B terminal in order to control the camcorder (including advanced recording functions) from a distance. The
remote controller lets you turn on the camcorder, navigate the menus and change settings, control the aperture
and shutter speed, change some custom picture settings, and more. When you use the REMOTE B terminal to
connect the RC-V100, the camcorder can receive and process multiple simultaneous commands from the
remote controller.
For details on how to connect and use the remote controller, refer to its instruction manual.
Operating modes:
1 Turn off the camcorder and connect the optional RC-V100 Remote Controller to the camcorder.
• Make sure that the remote controller's terminal selection switch is set to match the terminal to be used on
the camcorder.
2 Turn on the camcorder and select [REMOTE Term.].
> [B $ System Setup] > [REMOTE Term.]
3 Select [RC-V100 (REMOTE A)] or [RC-V100 (REMOTE B)] depending on the terminal used and then
press SET.
Options
[RC-V100 (REMOTE A)], [RC-V100 (REMOTE B)]:
Select this option to use the optional RC-V100 Remote Controller connected to the
corresponding REMOTE terminal.
[Standard]: Select this option to use commercially available remote controls.
NOTES
• When the camcorder is set to full auto mode (A 43), settings related to the aperture, gain, shutter speed and
white balance (except for [R Gain] and [B Gain] in the custom picture's [White Balance] settings*) cannot be
changed using the remote controller.
* When infrared recording is activated, even the WHITE BALANCE R and B dials will have no effect on the camcorder.
• Adjusting picture-related settings with the remote controller can be performed only when the detailed settings
were activated (
RR-10 or RR-100 8-pin
Remote Cable (optional)
Remote cable
(supplied with the RC-V100)
> [/ ! Custom Picture] > [Activate Other Settings] is set to [On], A 121).
Using the Optional RC-V100 Remote Controller
To the RC-V100's
REMOTE A terminal
39
To the RC-V100's
REMOTE B terminal