Using The Hdmi Out Terminal; Superimposing Onscreen Displays On Video Outputs - Canon XF705 Instruction Manual

Connecting to an External Monitor

Using the HDMI OUT Terminal

The digital signal that is output from the HDMI OUT terminal includes the video signal and audio signal. You can
output also the time code signal and some assistance displays (onscreen displays, markers, etc.) in order to
check them also on an external monitor.
146
The audio output signal will be 2-channel linear PCM audio (16-bit, 48 kHz sampling). You can select which
audio channels to output (A 150).
1 Select [SDI/HDMI Max Res.].
> [B " System Setup] > [SDI/HDMI Max Res.]
2 Select [3840x2160] or [1920x1080] and then press SET.
3 mode only: To output the time code signal, select [HDMI Time Code].
> [3 " Recording/Media Setup] > [HDMI Time Code]
4 Select [On] and then press SET.
NOTES
• The HDMI OUT terminal is for output only. Do not connect the camcorder to another device's output terminal
using the HDMI OUT terminal as this will cause a malfunction.
• Correct operation cannot be guaranteed when connecting the camcorder to DVI monitors.
• Video may not be output correctly depending on the monitor. In such case, use another terminal.
• You can set both
[On] to use the camcorder's REC button to control also the recording operation of an external recorder
connected to the HDMI OUT terminal. The camcorder's time code signal will be output as well.

Superimposing Onscreen Displays on Video Outputs

You can choose to output the camcorder's onscreen displays along with the video output from the SDI terminal
or HDMI OUT terminal to check the onscreen displays on an external monitor. This setting will not affect your
recordings.
1 Select the menu setting corresponding to the desired terminal.
> [¢ %* Monitoring Setup] > [OSD Output: SDI] or [OSD Output: HDMI]
* Appears on page $ in
2 Select [On] and then press SET.
mode, T appears on the right of the screen (only if [¢ % Monitoring Setup] > [Custom
• In
Display 2] > [OSD Output] is set to [On]). In
playback screen.
NOTES
• If you set an assignable button to [OSD Output: SDI/HDMI] (A 117), you can press the button to turn on and
off the superimposing of onscreen displays on all video outputs.
> [3 " Recording/Media Setup] > [Rec Command] and [HDMI Time Code] to
mode.
mode, the icon appears on the right of the screen in the