Reference Video Signal Output; Time Code Signal Output - Canon XF705 Instruction Manual

Synchronizing with an External Device

Reference Video Signal Output

After changing the G-LOCK/SYNC terminal's function to [HD Sync Output], you can output the camcorder's
video signal as a reference sync signal (HD tri-level signal) to synchronize an external device to this camcorder.
The reference video signal output will have the same frequency as the signal output from the SDI terminal.
94
Operating modes:
1 Select [G-LOCK/SYNC Term.].
> [B " System Setup] > [G-LOCK/SYNC Term.]
2 Select [HD Sync Output] and then press SET.
3 If necessary, you can change the scan mode (P or PsF) with the
[SYNC Scan Mode] setting.
Available synchronization signals
SDI terminal
2160/59.94P
2160/29.97P
2160/23.98P
2160/59.94P
2160/25.00p
1080/59.94P
1080/59.94i
1080/29.97P
1080/23.98P
1080/50.00P
1080/50.00i
1080/25.00P
* Change the scan mode (P or PsF) with the

Time Code Signal Output

The time code will be output from the TIME CODE terminal as an SMPTE-standard LTC timing signal. Before
connecting the device, set
terminal to output (A 93).
The embedded time code will be output also from the SDI terminal. Additionally, you can set
[3 " Recording/Media Setup] > [HDMI Time Code] to [On], to output the embedded time code also from the
HDMI OUT terminal.
Operating modes:
NOTES NOTES
• About the user bit output: In
the user bit will be output if it was recorded with the clip being played back.
• The time code and user bit will not be output when slow motion recording is activated.
• In mode, the time code and user bit will be output only from the SDI terminal.
SYNC terminal
1080/59.94i
1080/29.97 (P/PsF)*
1080/23.98P (P/PsF)*
1080/59.94i
1080/25.00P (P/PsF) *
1080/59.94i
1080/59.94i
1080/29.97P (P/PsF) *
1080/23.98P (P/PsF) *
1080/50.00i
1080/50.00i
1080/25.00P (P/PsF) *
> [B " System Setup] > [SYNC Scan Mode] setting.
> [B # System Setup] > [TC In/Out] to [Out] to change the TIME CODE
mode, the user bit set by the user (A 91) will be output. In
> [B " System Setup] >
>
mode,