Setting the User Bit
Setting the User Bit
The user bit display can be selected from the date or the time of recording, or an identification code consisting of
8 characters in the hexadecimal system. There are sixteen possible characters: the numbers 0 to 9 and the
76
letters A to F. The user bit can be output from the SDI OUT terminal (m only) and HDMI OUT terminal.
Operating modes:
Setting an Hexadecimal Code
1 Open the user bit setting screen.
> [3 # Recording Setup] > [User Bit Type] > [
• The user bit setting screen appears with an orange selection frame on the leftmost digit.
• Touch [Reset] to reset the user bit to [00 00 00 00] and return to the previous screen.
2 Touch [Í] or [Î] to set the first character and then touch the field next to it to select it.
• Change the rest of the characters in the same way.
3 After completing all the characters of the user bit, touch [OK].
• Touch [Cancel] to close the screen without changing the user bit.
Using the Date or Time
1 Select [User Bit Type].
> [3 # Recording Setup] > [User Bit Type]
2 Touch [
Date] or [
Time] and then touch [X].
Setting] > [i]