Setting The User Bit - Canon XA40 Instruction Manual

Setting the User Bit

The user bit display can be selected from the date or the time of recording, or an identification code
consisting of 8 characters in the hexadecimal system. There are sixteen possible characters: the
numbers 0 to 9 and the letters A to F. The user bit will be output from the SDI OUT terminal (s
only) and HDMI OUT terminal.
Operating modes:
1 Open the [User Bit Settings] screen.
> [3 # Recording Setup]
• To set the time for the user bit, select [
[ Date]. Then, select [
• The user bit setting screen will appear with the orange selection frame on the leftmost digit.
• To reset the user bit to [00 00 00 00], select [Reset].
• Select [Cancel] to close the screen without setting the user bit.
2 Select the digit you want to change and then select [
3 Select another digit you want to change.
4 Change the rest of the digits in the same way.
5 Select [OK] and then select [X].
NOTES
• The user bit will not be recorded with clips that are recorded to an SD card.
>
[User Bit Type]
Time] instead; to set the date for the user bit, select
X
]. The rest of the procedure is not necessary.
Setting the User Bit
>
[i]
Í] or [Î ] to change it as necessary.
67