Command Syntax - Keysight Technologies N3301A Programming Manual

SCPI Command Tree

Command Syntax

ABORt
CALibrate
:DATA <n> {,<n>,<n>}
:IMON:LEVel <points>
:IPRog:LEVel <points>
:LEVel <points>
:PASSword <n>
:SAVE
:STATE <bool> [,<n>]
CHANnel | INSTrument
[:LOAD]
INITiate
[:IMMediate]
:SEQuence[1] | :SEQuence2
:NAME LIST | ACQuire
CONTinuous
:SEQuence[1] <bool>
:NAME LIST <bool>
INPut | OUTput
[:STATe] <bool>
:PROTection
:CLEar
:SHORt
[:STATe] <bool>
MEASure | FETCh
:ARRay
:CURRent[:DC]?
:POWer[:DC]?
:VOLTage[:DC]?
[:SCALar]
:CURRent[:DC]?
:ACDC?
:MAX?
:MIN?
:POWer[:DC]?
:MAX?
:MIN?
:VOLTage[:DC]?
:ACDC?
:MAX?
:MIN?
PORT0 [:STATe] <bool>
PORT1 [:LEVel] <n>
Resets the trigger system to the Idle state
Enters the calibration data
Set cal points for current monitor offset (P1 | P2)
Set cal points for current monitor & programming (P1|P2|P3|P4)
Set cal points for the selected function (P1 | P2)
Set calibration password
Save new cal constants in non-volatile memory
Enable or disable calibration mode
Selects a channel in the mainframe
Initiates a specific numbered sequence
Initiates a specific named sequence
Sets continuous initialization
Sets continuous initialization
Enables/disables the input
Reset latched protection
Enables/disables the input short
Returns the digitized instantaneous current
Returns the digitized instantaneous power
Returns the digitized instantaneous voltage
Returns the input current
Returns the total rms current (ac+dc)
Returns maximum current
Returns minimum current
Returns the input power measurement
Returns the maximum input power measurement
Returns the minimum input power measurement
Returns the input voltage
Returns the total rms voltage (ac+dc)
Returns maximum voltage
Returns minimum voltage
Enables/disables the general purpose digital port
Programs the general purpose digital port
A
105