Sense:current:range; Sense:sweep:points; Sense:sweep:offset - Keysight Technologies N3301A Programming Manual

SENSe:CURRent:RANGe

Channel Specific
This command sets the current measurement range. There are two current measurement ranges:
High Range: model dependent, see Table 4-1
Low Range: model dependent, see Table 4-1
A value of infinity is returned if the measured value is outside the specified current measurement range.
Command Syntax
Parameters
*RST Value
Examples
Query Syntax
Returned Parameters

SENSe:SWEep:POINts

Channel Specific
This command specifies how many data points are taken in any measurement. Applies to both voltage
and current measurements. The number of points can be specified, from 1 to 4096.
Command Syntax
Parameters
*RST Value
Examples
Query Syntax
Returned Parameters
Related Commands

SENSe:SWEep:OFFSet

Channel Specific
This command specifies a delay time after the trigger, but before the measurement is taken. The delay is
specified in seconds. The measurement offset can be either positive or negative with respect to the
trigger.
Negative measurement offsets can only be programmed in conjunction with delayed
NOTE:
triggers. The negative measurement offset cannot exceed the trigger delay value.
Command Syntax
Parameters
*RST Value
Examples
Query Syntax
Returned Parameters
Related Commands
SENSe:CURRent:RANGe <NRf+>
0 through MAX | MINimum | MAXimum
A (amperes)
Unit
MAX (high range)
SENS:CURR:RANGE MIN
SENSe:CURRent:RANGe?
<NR3>
SENSe:SWEep:POINts <NRf+>
1 through 4096 | MINimum | MAXimum
1000
SENS:SWE:POIN 2048
SENSe:SWEep:POINts?
<NR3>
SENS:SWE:TINT
SENSe:SWEep:OFFSet <NRf+>
0 through 0.032 | MINimum | MAXimum
Unit seconds
0 (zero)
SENS:SWE:OFFS 0.01
SENSe:SWEep:OFFSet?
<NR3>
SENS:SWE:TINT
MEAS:ARR
MEAS:ARR
Language Dictionary - 4
75