Transient Commands; [Source:]Transient; [Source:]Transient:dcycle; [Source:]Transient:frequency - Keysight Technologies N3301A Programming Manual

Dc electronic loads
Table of Contents

Advertisement

Transient Commands

These commands program the transient generator of the electronic load. The transient generator
programs a second (transient) level at which the electronic load can operate without changing the original
programmed settings.
See also [SOURce:]CURRent:TLEVel, [SOURce:]RESistance:TLEVel, and [SOURce:]VOLTage:TLEVel
in the Input Commands section.

[SOURce:]TRANsient

Channel Specific
This command turns the transient generator on or off.
Command Syntax
Parameters
*RST Value
Examples
Query Syntax
Returned Parameters
Related Commands

[SOURce:]TRANsient:DCYCle

Channel Specific
This command sets the duty cycle of each of the transients when the generator is in CONTinuous mode.
Command Syntax
Parameters
*RST Value
Examples
Query Syntax
Returned Parameters
Related Commands

[SOURce:]TRANsient:FREQuency

Channel Specific
This command sets the frequency of the transients when the generator is in CONTinuous mode.
Command Syntax
Parameters
*RST Value
Examples
Query Syntax
Returned Parameters
Related Commands
[SOURce:]TRANsient[:STATe] <bool>
0 | 1 | OFF | ON
OFF
TRAN 1
TRAN 0
[SOURce:]TRANsient[:STATe]?
<NR3>
TRAN:MODE
[SOURce:]TRANsient:DCYCle <NRf+>
1.8% - 98.2% | MAXimum | MINimum
50%
percent
Unit
TRAN:DCYC 10.5
[SOURce:]TRANsient:DCYCle?
<NR3>
TRAN:MODE
[SOURce:]TRANsient:FREQuency <NRf+>
0.25Hz - 10kHz | MAXimum | MINimum
Hertz
Unit
MAXimum
TRAN:FREQ 50
[SOURce:]TRANsient:FREQuency?
<NR3>
TRAN:DCYC
TRAN:FREQ
TRAN:DCYC 50
TRAN:FREQ
TRAN:FREQ 5
TRAN
Language Dictionary - 4
89

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the N3301A and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

N3300aN3302aN3305aN3303aN3307aN3306a ... Show all

Table of Contents