Sense:sweep:tinterval; Sense:window; Sense:voltage:range - Keysight Technologies N3301A Programming Manual

4 - Language Dictionary

SENSe:SWEep:TINTerval

Channel Specific
This command defines the time period between measurement points. The time interval can be
programmed from 0.00001 to 0.032 seconds in 10 microsecond increments.
Command Syntax
Parameters
*RST Value
Examples
Query Syntax
Returned Parameters
Related Commands

SENSe:WINDow

Channel Specific
This command sets the window function that is used in dc and ac+dc rms measurement calculations. The
following functions can be selected:
A signal conditioning window that reduces errors in dc and rms measurement
HANNing
calculations in the presence of periodic signals such as line ripple. It also reduces
jitter when measuring successive pulses. The Hanning window multiplies each point
in the measurement sample by the function cosine
window when measuring single-shot pulses.
A window that returns measurement calculations without any signal conditioning.
RECTangular
Neither window function alters the voltage or current data in the measurement array.
NOTE:
Command Syntax
Parameters
*RST Value
Examples
Query Syntax
Returned Parameters

SENSe:VOLTage:RANGe

Channel Specific
This command sets the voltage measurement range. There are two voltage measurement ranges:
High Range: model dependent, see Table 4-1
Low Range: model dependent, see Table 4-1
A value of infinity is returned if the measured value is outside the specified voltage measurement range.
Command Syntax
Parameters
*RST Value
Examples
Query Syntax
Returned Parameters
Related Commands
76
SENSe:SWEep:TINTerval <NRf+>
0.00001 - 0.032 | MAXimum | MINimum
Unit seconds
10 µs
SENS:SWE:TINT 100E-6
SENSe:SWEep:TINTerval?
<NR3>
SENS:SWE:OFFS:POIN
SENSe:WINDow[:TYPE] <type>
RECTangular | HANNing
RECTangular
SENS:WIND HANN
SENSe:WINDow?
<CRD>
SENSe:VOLTage:RANGe[:UPPer] <NRf+>
0 through MAX | MINimum | MAXimum
V (voltage)
Unit
MAX (high range)
SENS:VOLT:RANGE MIN
SENSe:VOLTage:RANGe?
<NR3>
SENS:SWE:TINT
MEAS:ARR
4 . Do not use the Hanning
MEAS:ARR