Inverter Running - Run; Frequency Arrival Signal - Far - FujiFilm FVR-Micro Instruction Manual

The table below lists functions that can be assigned to terminals [Y1] and [30A/B/C].
To make the explanations simpler, the examples shown below are all written for the normal
logic (Active ON).
Function code data
Active ON Active OFF
0
1
2
3
5
6
7
26
35
36
37
38
41
43
44
56
57
59
84
87
90
91
99
 Inverter running -- RUN (Function code data = 0)
This output signal tells the external equipment that the inverter is running at a starting frequency
or higher. It comes ON when the output frequency exceeds the starting frequency, and it goes
OFF when it is less than the stop frequency. It is also OFF when the DC braking is in operation.
If this signal is assigned in negative logic (Active OFF), it can be used as a signal indicating
"Inverter being stopped."
 Frequency arrival signal -- FAR (Function code data = 1)
This output signal comes ON when the difference between the output frequency and reference
frequency comes within the frequency arrival hysteresis width specified by E30. (Refer to the
description of E30.)
1000 Inverter running
1001 Frequency arrival signal
1002 Frequency detected
1003 Under voltage detected (Inverter stopped)
1005 Inverter output limiting
1006 Auto-restarting after momentary power failure
1007 Motor overload early warning
1026 Auto-resetting
1035 Inverter running 2
1036 Overload prevention control
1037 Current detected
1038 Current detected 2
1041 Low current detected
1043 Under PID control
Motor stopped due to slow flowrate under PID
1044
control
1056 Motor overheat detected by thermistor (PTC)
1057 Brake signal
1059 Terminal [C1] wire break
1084 Maintenance timer
1087 Frequency arrival detected
1090 Traverse Up
1091 Traverse Out
1099 Alarm output (for any alarm)
Functions assigned
5-50
Symbol
RUN
FAR
FDT
LU
IOL
IPF
OL
TRY
RUN2
OLP
ID
ID2
IDL
PID-CTL
PID-STP
THM
BRKS
C1OFF
MNT
FARFDT
TRV_UP
TRV_OUT
ALM