Coefficient For Constant Feeding Rate Time; Coefficient For Speed Indication; Keypad - FujiFilm FVR-Micro Instruction Manual

 Low current detected -- IDL
This signal turns ON when the output current drops below the low current detection level
(E34) and remains at the low level for the timer period (E35). When the output current
exceeds the "Low current detection level plus 5% of the inverter rated current," it goes OFF.
(The minimum ON-duration is 100 ms.)
E39

Coefficient for Constant Feeding Rate Time

E50

Coefficient for Speed Indication

E39 and E50 specify coefficients for determining the constant feeding rate time, load shaft
speed, and line speed, as well as for displaying the output status monitored.
Calculation expression
Constant feeding rate time (min) =
Load shaft speed = Coefficient for speed indication (E50) × Frequency (Hz)
Line speed = Coefficient for speed indication (E50) × Frequency (Hz)
Where, the "frequency" refers to the "reference frequency" to be applied for settings (constant
feeding rate time, load shaft speed, or line speed), or to the "output frequency before slip
compensation" to be applied for monitor.
If the constant feeding rate time is 999.9 min. or more or the denominator of the right-hand side is
zero (0), "999.9" appears.
E52
Keypad (Menu display mode)
E52 provides a choice of three menu display modes for the keypad as listed below.
Data for E52
0
1
2
Selecting the full-menu mode (E52 = 2) allows you to cycle through the menus with
the
menu has been cycled through, the display returns to the first menu item.
Coefficient for speed indication (E50)
Frequency × Coefficient for constant feeding rate time (E39)
Menu display mode
Function code data editing mode
Function code data check mode
Full-menu mode
* Menus #1 through #7 when a remote keypad is connected.
or key and select the desired menu item with the
5-55
Menus to be displayed
Menu #1
Menu #2
Menus #1 through #6 *
key. Once the entire