FujiFilm FVR-Micro Instruction Manual page 43

(E codes continued)
Code Name
Current Detection 2
E37
E38
E39
Coefficient for Constant
Feeding Rate Time
E40
PID Display Coefficient
A
E41 PID Display Coefficient
B
E42 LED Display Filter
E43 LED Monitor
(Display item)
E48 LED Monitor
(Speed monitor item)
E50 Coefficient for Speed
Indication
E52
Keypad
(Menu display mode)
(Note) E45, E46 and E47 appear on the LED monitor, but cannot be used by this inverter.
*1 When you make settings from the keypad, the incremental unit is restricted by the number of digits that the LED
monitor can display.
(Example) If the setting range is from -200.00 to 200.00, the incremental unit is:
"1" for -200 to -100, "0.1" for -99.9 to -10.0 and for 100.0 to 200.0, and "0.01" for -9.99 to -0.01 and for 0.00 to 99.99.
*2 The significant figure is in three digits, so the incremental unit changes depending upon the magnitude of absolute values.
(Example) The incremental unit is "10" for 1000 to 9990, "1" for -999 to -100 and for 100 to 999, "0.1" for -99.9 to -10.0 and
for 10.0 to 99.9, and "0.01" for -9.99 to 9.99.
Data setting range
0.00 (Disable), 0.01 to 100.0
(Level) Current value of 1 to 200% of the inverter
rated current
(Timer) 0.01 to 600.00 *1
0.000 to 9.999
-999 to 0.00 to 9990 *2
-999 to 0.00 to 9990 *2
0.0 to 5.0
0: Speed monitor (select by E48)
3: Output current
4: Output voltage
10: PID command
12: PID feedback amount
13: Timer
14: PID output
0: Output frequency (Before slip
compensation)
1: Output frequency (After slip
compensation)
2: Reference frequency
4: Load shaft speed in r/min
5: Line speed in m/min
6: Constant feeding rate time
0.01 to 200.0 *1
0: Function code data editing mode
(Menu #1)
1: Function code data check mode
(Menu #2)
2: Full-menu mode (Menus #0 through
#6)
Incre-
Unit
ment
0.01
0.01
0.001
0.01
0.01
0.1
–
–
0.01
–
5-8
Change
Data Default
when
copying setting
running
A Y Y1 See
Y2 Table
s Y Y 10.00
– Y Y 0.000
– Y Y 100
– Y Y 0.00
s Y Y 0.5
– Y Y
– Y Y
– Y Y 30.00
– Y Y
A.
0
0
0