Overview Of Operation Modes; Simultaneous Keying; Status Transition Between Operation Modes - FujiFilm FVR-Micro Instruction Manual

Simultaneous keying

Simultaneous keying means pressing two keys at the same time (expressed by "+"). FVR-Micro
supports simultaneous keying as listed below.
(For example, the expression "
key.)
Table 3.2 Simultaneous Keying
Operation mode
Running mode
Programming mode
Alarm mode
About changing of function code data
The function code data can be changed only when the data value displayed on the LED monitor is
flashing.
When the data value is lit, no change is allowed. To change the data, stop the inverter or disable the
data protection.

3.2 Overview of Operation Modes

FVR-Micro features the following three operation modes:
Running mode
Programming mode : This mode allows you to configure function code data and check a variety of
information relating to the inverter status and maintenance.
Alarm mode
mode, you can view the corresponding alarm code* and its related information on the LED monitor.
* Alarm code: Indicates the cause of the alarm condition that has triggered the protective function. For
details, refer to Chapter 8, Section 8.3 "Protective Functions."
Figure 3.1 shows the status transition of the inverter between these three operation modes.
Figure 3.1 Status Transition between Operation Modes
+ keys" stands for pressing the
Simultaneous keying
+ keys
+ keys
+ keys
: This mode allows you to enter run/stop commands in regular operation.
You can also monitor the running status in real time.
: If an alarm occurs, the inverter automatically enters the Alarm mode. In this
Control entry to/exit from jogging operation.
Change certain function code data.
(Refer to function codes F00, H03, H45 and H97 in
Chapter 5 "FUNCTION CODES.")
Switch to Programming mode without clearing alarms.
3-2
key while holding down the
Used to: