Chrysler Stratus RHD 1997 Interactive Electronic Service Manual page 1227

CLUTCH REAC- REVERSE TION REVERSE MUST SNAP REVERSE HOOK T OOL RAISE SNAP RING SCREW- TION PLATE PLATE DRIVER (SELECT) CLUTCH REAC- RAISE RING TO
21 - 96 TRANSAXLE
DISASSEMBLY AND ASSEMBLY (Continued)
Fig. 224 Install Reverse Clutch Snap Ring
Fig. 225 Seating Snap Ring to Determine
ReverseClutch Clearance
Fig. 226 Check Reverse Clutch Pack Clearance
SNAP RING WITH COMPRESS CLUTCH PACK FINGER INDICATOR TO SCREW- SCREW- DRIVER ZERO DRIVER UNDERDRIVE BEARING #2 (NOTE #2 SMALL TABS) BEARING NEEDLE NEEDLE ASSEMBLY 3
The reverse clutch pack clearance is 0.76 to
1.24 mm (.030 to .049 inch). Select the proper
reverse clutch snap ring to achieve specifications:
1.56 mm (.061 in.)
1.80 mm (.071 in.)
2.05 mm (.081 in.)
2.30 mm (.090 in.)
REVERSE CLUTCH SNAP RING CHART
All clutch clearances in the input clutch retainer
have now been checked and approved.
To complete the assembly of the input clutch
retainer, the reverse clutch and the overdrive clutch
must be removed from the retainer.
CAUTION: Do not intermix clutch parts. Keep in
exact same order.
Now proceed with the next phase of the assembly:
Fig. 227 Install No. 2 Needle Bearing
Fig. 228 Install Underdrive Shaft Assembly
SHAFT
THICKNESS
TABS UP
JA