Data Replay Menu; Y-T Replay - GRAPHTEC GL980 User Manual

CHAPTER 3 Settings and Measurement

(8) Data replay menu

Select the data you want to replay from the "Data replay source" by pressing the [REVIEW] key and replay
the captured data.
Press [MENU] key during replaying to display the data replaying menu.
< Y-T replay >

Y-T replay

Cursor Position
Data Search
Statistical Calculation
Set XY Display
3-130
Setting
Move to First
Move to Last
Move to Center
Move to Trigger
Move to Selected Selection method
[Position]
[Time]
Call Other Cursor
Cursor Sync
Combination
Mode
[Analog CH]
[Logic CH]
[Pulse CH]
[Alarm]
Level settings
Next Search
Prev. Search
CH
Trace
Position
Vernier
< XY replay >
Move the selection cursor to the top of the data.
Move the selection cursor to the end of the data.
Move the selection cursor to the middle position of the data.
Move the selection cursor to the position where the trigger
occurred.
Set the method to specify the destination.
Position, Time
Moving Specify the movement position as relative time from the
position trigger point.
Moved Specify the moving point by date and time of the data.
date/time
Move the other cursor to the position of the currently selected
cursor.
Set the synchronous movement of the cursor.
Off, On
Set a combination of search conditions.
Edge OR, Edge AND
Set the search mode. Set it for each CH.
Off, Rising, Falling, Window In, Window Out
Off, H, L
* Logic CH is used for pattern comparison of all the logic CH.
Off, Rising, Falling, Window In, Window Out
Off, Output 1, Output 2, Output 3, Output 4
Enter the search level as a numerical value. If it is within the
range/out of range, you should set two places.
Search the next (future) position matching the search
condition from the current cursor position.
Search the previous (future) position matching the search
condition from the current cursor position.
Execute the statistical calculation between cursors.
Perform the settings for XY display.
Set X-axis and Y-axis of XY graph.
CH1 to CH8
Set the trace of XY graph.
Off, On
Waveforms are not displayed on the screen when the trace is
set to Off. Also it is not displayed on the digital display.
Set the XY position.
0 to 100%
Set the XY Vernier.
40 to 100%
* The range varies depending on the range setting.
Description