Repeated Capturing; Repeat Interval Mode And Repeat Interval - GRAPHTEC GL980 User Manual

(4)-4 Repeated capturing

This is used to enable or disable the repeat function to conduct repeated capturing.
Selection item
Off
On
Repeat capture is available when the capturing destination is internal RAM or when the stop trigger is set.

Repeat interval mode and repeat interval

When the repeat capture function is set to On, you can set the time interval until the next recording starts.
The time interval range is set in the repeat interval mode.
< Repeat interval mode >
Setting
Start - Start
Stop - Start
Waiting for
trigger
Waiting for
trigger
When the time interval between start and stop is set and the set time interval has passed at the end of the
capturing, repeat operation starts immediately.
When the repeat interval is set to 0 hour 0 minute 0 second, repeat operation starts immediately.
The repeat interval may be longer than the set time .
The repeat function is disabled.
The repeat function is enabled. After one capture ends, the next capture starts (If the start
side source setting is not Off, this device waits for a trigger).
Set the time from the previous capture start (including waiting for trigger) to the start of next
recording.
Set the time from the previous capture stop to the start of next recording.
Stop - Start
Captured data
Stop - Start
Captured data
CHAPTER 3 Settings and Measurement
Description
Description
Waiting for
Captured data
trigger
Waiting for
Captured data
trigger
3-99