Backup Setting - GRAPHTEC GL980 User Manual

(2)-13 Backup setting

This device has a function to periodically back up recorded data.
(Refer to the figure below.)
Measurement input
Setting
(1) Backup intervals
(2) Backup Destination
(3) Save folder
If ring capture is On, the backup function is not available.
When set to the CSV file format, the sampling interval is from 10 ms.
To replace the backup destination media, be sure to execute the Remove/Replace in the File menu before
replacing.
If the sampling time is faster because the number of effective CHs is large, or the backup interval is longer,
the size of the data to be backed up increases, so it may take time to finish writing at the time of capturing
stop.
When saving to an FTP server, backup may fail depending on the communication environment and transfer
speed.
Automatic backup to an FTP server
GL980
(1)
(2)
(3)
Set the interval to back up the captured data.
Off, 1, 2, 6, 12, 24 hours ;specified time
Set the backup destination of the captured data.
Internal memory
SD card
USB memory
FTP
* Capturing destination and backup destination cannot be the same.
* When SD card or USB memory is selected as backup destination, SD card and USB memory
can be replaced. For details, refer to "3.5 Setting Menus" - "7. File menu".
* The FTP server settings must be made using the Interface settings.
(Refer to "FTP/WEB server settings".)
Set the folder to save the backup file.
* This must be a folder on the Internal memory,SD card,USB memory or an FTP server.
Example) \GRAPHTEC\¥20171001
CHAPTER 3 Settings and Measurement
Ethernet
FTP server
Auto backup to SD memory card or USB memory
Description
: The data is backed up to the internal memory of the device.
: The data is backed up to the SD card.
: The data is backed up to the USB memory.
: Backs up data to an FTP server on the network.
3-81