Toyota Tercel 1985 Repair Manual page 577

BR-l8
BRAKE SYSTEM - Front Brake
' -
t . t
d[
(c! Install the pads onto each support plate'
9.
INSTALL NEW ANTI-SOUEAL SPRINGS
10. INSTALL CYLINDER
(d
Draw out a small amount of brake fluid from the
reservoir.
(b) Press in piston with a hammer handle or such.
NOTE: Always change the pad on one wheel at a time as
there is possibility of the opposite piston flying out
(c) Insert the brake cylinder carefully so the dust boot is
not wedged.
t1.,
(d) lrfiiprr and torque the two instatlation bolts.
Torque: 255 kg-cm (18 ft-lb, 25 N'ml
t t. tNsrArL FRoNr Itr#
*12. CHECK THAT FLUID TEVEL IS AT "MAX" LINE
I
,iw
,i
REMOVAL OF CYUTNDER
'
(See page BR-l61
1.
REMOVE CYLINDER
(a) Using SST, disconnect the brake line.
Use a container to catch the brake fluid.
ssT 09751 -3601 1
(b) Rembve the two installation bolts and cylinder.
2.
REMOVE PADS (See step 4 on.page BR-l71
DISASSEMBLY OF CYLINDER
(See page BR-l61
1.
REMOVE FOLLOWING PARTS:
(a) Two slide bushings
(b) Four dust boots
(d
Two collars
I'id
r
SST
" ' L i -