Toyota Tercel 1985 Repair Manual page 548

RA-/[()
REAR AXLE AND SUSPENSION - Differential (4WD)
RAOO3
(b) Coat the threads of a new nut with MP grease.
(c) Using SST to hold the flange, tighten the nut.
Torque the nut.
ssr 09330-ooo20
Torque: 1,425 kg-cm (103 ft-lb, 140 N'ml
12. ADJUST DRIVE PINION PRELOAD
Using a torque wrench, measure the preload of the back-
lash between the drive pinion and ring gear.
Preload: New bearing
6.5 - 12.5 kg-cm
(5.6 - 10.9 in.-lbl
(0.6 - 1.2 N'ml
Reused bearing 4 - 7 kg-cm
(3.5 - 6.1 in.-lbl
(0.4 - 0.7 N'ml
lf preload is exceeds specification, replace the bear-
ing spacer.
lf preload is less than specification, retighten the nut
130 kg-cm (9 ft-lb, 13 N.m) at a time until the
specified preload is reached.
lf the maximum torque is exceeded while retightening the
nut, replace the bearing spacer and repeat the preload pro-
cedure. Do not back off the pinion nut to reduce the
preload.
Maximum torque: 2,4OO kg-cm
(174 ft-lb, 235 N'm)
CHECK DEVIATION OF COMPANION FLANGE
Maximum tateral runout: 0.10 mm (0.0039 in.l
Maximum radial runout:
0.10 mm (0.0039 in.l
14. STAKE DRIVE PINION NUT
(a)
(b)
1 3 .