Toyota Tercel 1985 Repair Manual page 497

FRONT AXLE AND SUSPENSION - Front Drive Shaft
F A - l 7
6. INSTALL NEW SNAP RING
Using snap ring pliers, install a new snap ring.
7. ASSEMBLE BOOT TO OUTBOARD JOINT SHAFT
Before assembling the boot pack in 24O g (0.5 lb) of
grease.
NOTE: Use the grease supplied in the boot kit.
8. ASSEMBLE INBOARD JOINT TO DRIVE SHAFT
(a) Pack in 140 g (0.3 lb, 1 .4 N) of grease.
Amount:
Joint side 90 g {0.2 lOl
Boot side
50 g (0.1 lul
NOTE: Use the grease supplied in the boot kit.
(b) Align the matchmarks placed before disassembly.
(c) lnstall the inboard joint shaft to the drive shaft.
(d) lnstall.lF Uoo, to the inboard joint shaft.
9. ASSEMBLE BOOTS CLAMP TO BOTH BOOTS
(d
Be sure the boot is on the shaft groove.
(b) Install a new 4amp on the inboard joint side around
the hollow pffin
of the cover.
' \ .
.-"
e_