Toyota Tercel 1985 Repair Manual page 547

REAR AXLE AND SUSPENSION - Differential (4WD)
RA.39
NOTE: lf adjusting the meshing of the teeth of the drive
pinion and ring gear by changing the extension of the drive
pinion, select a thrust washer of the appropriate thickness
from the table below.
REMOVE COMPANION FLANGE
(See step 7 on page RA-31)
REMOVE FRONT BEARING
(See step 9 on page RA-31)
INSTALL NEW BEARING SPACER AND FRONT
BEARING
(d
lnstall a new bearing spacer on the shaft.
(b) lnstall the front bearing on the shaft.
10. INSTALL OIL SLINGER AND NEW OIL SEAL
(d
Install the oil slinger facing as shown.
(b) Using SST, drive in a new oil seal as shown.
ssT 0951 7-12010
Oil seal drive in depth: 1.0 mm (0.039 in.)
(d
Apply MP grease to the oil seal lip.
1 1 . I N S T A L L C O M P A N I O N F L A N G E
(a) Using SST, install the companion flange.
ssr 09557-22022
7.
8.
9.
Drive in depth
Drive pinion thrust washer thickness
mm (in.)
2.24 (O.O882)
|
Z.+8 (0.0976)
2.27 l}.O8e4l
I
Z.S1 (0.0988)
2.30 (0.0906)
I
Z.S4 (0.1000)
2 . 3 3 ( 0 . 0 9 1 7 )
|
2 . 5 7 ( 0 . 1 0 1 2 )
2.36 (O.Os29)
|
Z.A0 {0.1024)
2.39 (0.0941)
I
2.63 (0.103s)
2.42 (0.0953)
|
Z.A6 (0.1047)
2.45 (0.096s)