Toyota Tercel 1985 Repair Manual page 495

FRONT AXLE AND SUSPENSION - Front Drive Shaft
F A - l 5
4. DISASSEMBLE INBOARD JOINT SHAFT
(d Place matchmarks on the inboard joint shaft and
drive shaft.
CAUTION: Do not use a punch.
(b) Remove the inboard joint from the drive shaft.
5.
DISASSEMBLE TRIPOD JOINT
{a) Using snap ring pliers, remove the snap ring.
(d
Using a punch and hammer place matchmarks on the
shaft and tripod.
(d
Uniformily tap to remove the tripod joint from the
drive shaft.
CAUTION: Do not tap on the roller.
6.
REMOVE FOLLOWING PARTS:
(a) Remove the boot from the drive shaft
(b) Remove the clamp and dynamic damper (LH shaft
only.)
i,l_
n r n
(c) Remove the two boot clamps from the boot of the
outboard joint.
(d) Remove the boot from the outboard joint.
CAUTION: Do not remove the outboard joint.
(e) Check the inside and outside of the boot for damage.
Do not remove.
- f f i , , . @ ,