Toyota Tercel 1985 Repair Manual page 534

RA-26 REAR AXLE AND SUSPENSION - Rear Axte Shaft (4WD)
INSPECTION AND REPAIR OF REAR AXLE
SHAFT COMPONENTS
1. INSPECT REAR AXLE SHAFT AND FLANGE FOR
WEAR, DAMAGE OR RUNOUT
Maximum shaft runout: 1.5 mm {0.059 in.}
Maximum flange runout: 0.1 mm (0.0O4 in.)
lf the rear axle shaft or flange is damaged or worn, or if
their runout is greater than maximum, replace the rear axle
shaft.
INSPECT REAR AXLE BEARING FOR WEAR OR
DAMAGE
lf the bearing is damaged or worn, replace it.
REMOVE BEARING INNER RETAINER
(a) Using a grinder, grind down the inner retainer.
(b) Using a chisel and hammet cut off the retainer and
remove it from the shaft.
REMOVE BEARING FROM SHAFT
Using SST, press the bearing off the shaft.
ssT 09527-2001 1
INSTALL BEARING OUTER RETAINER AND NEW
BEARING ON SHAFT
Using SST, press on the bearing outer retainer and new
bearing.
s s T 0 9 5 1 5 - 2 0 0 1 0
6. INSTALL BEARING INNER RETAINER ON SHAFT
(d
Gradually heat the bearing inner retainer to about
150'C (302'F) in an oil bath.
2.
3.
150'c
lnner Retainer