PROPELLER SHAFT - Propeller Shaft
PR.3
REMOVAL AND DISASSEMBLY OF
PROPELLER SHAFT
(See page PR-21
1.
DISCONNECT PROPELLER SHAFT FLANGE FROM
COMPANION FLANGE ON DIFFERENTIAL
(a) Place matchmarks on the flanges.
(b) Remove the four bolts and nuts.
2.
REMOVE TWO BOLTS HOLDING CENTER SUPPORT
BEARING TO BODY
3.
REMOVE PROPELLER SHAFT WITH INTERMEDIATE
SHAFT
h)
Pull out the yoke from the transmission.
(b) Insert SST in the transmission to prevent oil leakage.
s s T 0 9 3 2 5 - 1 2 0 r O
4.
SEPARATE PROPELLER SHAFT AND INTERMEDIATE
SHAFT
(a) Place matchmarks on the flanges.
(b) Remove the four bolts and nuts.
5.
REMOVE CENTER SUPPORT BEARING FROM
INTERMEDIATE SHAFT
(a) Using a hammer and chisel, loosen the staked part of
the nut.
(b) Using SST to hold the flange, remove the nut.
ssT 09330-00020