Lateral Control Rod - Toyota Tercel 1985 Repair Manual

RA-/t6
REAR AXLE AND SUSPENSION - Four Link Type Rear Suspension (4WD)
9. TIGHTEN LATERAL CONTROL ROD NUT
h)
Raise the axle housing until the body is free from the
stands.
(b) Torque the lateral control rod nut.
Torque: 650 kg-cm (47 ft-lb, 64 N'm)
Lateral Control Rod
(See page RA-421
REMOVAL OF LATERAL CONTROL ROD
1. SUPPORT REAR AXLE HOUSING
Jack up the rear axle housing and support it with stands.
2.
DISCONNECT LATERAL CONTROL ROD FROM REAR
AXLE HOUSING
Remove the nut holding the lateral control rod to the rear
axle housing, and disconnect the lateral control rod.
3.
DISCONNECT LATERAL CONTROL ROD FROM BODY
Remove the nut holding the lateral control rod to the body
and remove the lateral control rod.
REPLACEMENT OF LATERAL CONTROL ROD
B U S H I N G
1.
REMOVE BUSHING
Using SST, press out the bushing from the lateral control
rod.
ssT 0971 0-14012
NOTE: When inserting and removing the bushing, press
or pull from the chamfered side as shown in the figure.
t
Remove