Toyota Tercel 1985 Repair Manual page 496

FA-l6
FRONT AXLE AND SUSPENSION - Front Drive Shaft
T
V inylTape
406 mm
r
(15.98 in.)
|
ASSEMBLY OF FRONT DRIVE SHAFT
(See page FA-l41
1. PROVISIONALLY INSTALL BOOT AND BOOT CLAMP
TO OUTBOARD JOINT
NOTE: Before installing the boot wrap vinyltape around
the spline of the shaft to prevent damaging the boot.
INSTALL DYNAMIC DAMPER AND CLAMP
(LH SHAFT onlyl
PROVISIONALLY INSTALL BOOT AND CLAMP
(For INBOARD JOINTI TO DRIVE SHAFT
ASSEMBLE BOOT CLAMPS ONTO DRIVE SHAFT
ASSEMBLE TRIPOD JOINT
(a) Place the beveled side of the tripod axial spline
toward the outboard joint.
(b) Align the matchmarks placed before disassembly.
When replacing the inboard joint, first align the
center of the inboard joint and outboard joint.
Using a brass bar and hammer, tap the tripod onto
the drive shaft.
2.
3.
4.
5.
(c)
i
I . {
-^'re
t , - /
(d)