Toyota Tercel 1985 Repair Manual page 530

a
REAR AXLE AND SUSPENSION
(d
Connect the suspension arm to the axle carrier with
the bolt and nut. Do not torque the bolt yet.
NOTE: When connecting the suspension arm, insert the
lip of the nut into the hole on the suspension.
2. INSTALL NO.2 SUSPENSION ARM
(a) Place the suspension arm in position.
(b) lnstall the cam and bolt holding the suspension arm
to the body. Do not torque the bolt yet.
(c) Align the cam plate mark at the same position it was
before removal.
(d) Install the bolt and nut holding the suspension arm to
the axle carrier. Do not torque the bolt yet.
NOTE: Be sure the lip of the nut is resting on the flange
of the suspension arm, not over it.
3. TOROUE SUSPENSION ARM SETTING BOLTS
(a) Remove the stands and bounce the vehicle to stabi-
lize the suspension.
(d
Torque the setting bolts with the vehicle weight on
the suspension.
Torque: 89O kg-cm (64 ft-lb, 87 N.ml
4. CHECK REAR WHEEL ALTGNMENT (See page RA-31