Reference Edit Option; Editing A Reference Value - ABB ACL30 User Manual

122 Using the control panel

Reference Edit option

In the Reference Edit option, you can:
• accurately control the local reference value,
• start, stop, change the direction and switch between local and remote control.
Editing is allowed only in the LOC state; the option always edits the local reference
value.


Editing a reference value

Step Action
1. If the panel is in the remote control mode (REM
shown on the status line), switch to local control
(LOC shown on the status line) by pressing
Reference editing is not possible in the remote
control mode. If you try to enter REF EDIT in the
remote control mode, the display shows a
message about that.
2. Otherwise, go to the Main menu by pressing
if you are in the Output mode, otherwise by
EXIT
pressing
menu.
3. Go to the Reference Edit option by selecting REF
EDIT on the menu with keys
and pressing
4. Select the correct sign with keys
, and press
numbers with keys
each number is selected, press
not select a number for a couple of seconds, the
number you are editing moves on to the next one
on the right.
repeatedly until you get to the Main
ENTER
.
NEXT
. Select the correct
and
NEXT
REM
Reference editing
enabled only in
LOC
.
local control mode
REM
MENU
LOC
PARAMETERS
ASSISTANTS
CHANGED PAR
EXIT
LOC
and ,
+
CANCEL
and
LOC
-
, and after
. If you do
CANCEL
Display
MESSAGE
00:00
MAIN MENU
00:00 ENTER
REF EDIT
0000.00
rpm
00:00 NEXT
REF EDIT
1250.00
00:00 SAVE
1
rpm