Fault tracing
Contents of this chapter
The chapter lists the alarm and fault messages including possible causes and
corrective actions.
Safety
See
Safety instructions
Alarm and fault indications
An alarm or a fault message indicates abnormal drive status. Most alarm and fault
causes can be identified and corrected using this information. If not, an ABB
representative should be contacted.
The alarm/fault code is displayed on the 7-segment display of the drive. The following
table describes the indications given by the 7-segment display.
Display
"E-" followed by error code
"A-" followed by error code
"F-" followed by error code
on page 13.
Meaning
System error. See the appropriate drive Hardware manual.
Alarm. See section
page 290.
Fault. See section
page 299.
12
Alarm messages generated by the drive
Fault messages generated by the drive
Fault tracing 289
on
on