Setting Speed Reference In The Output Mode; Adjusting Display Contrast In The Output Mode - ABB ACL30 User Manual

96 Using the control panel


Setting speed reference in the Output mode

See also section Reference Edit option on page 122.
Step Action
1. If you are not in the Output mode, press
repeatedly until you get there.
2. If the drive is in remote control (REM shown on the
status line), switch to local control by pressing
LOC
. The display briefly shows a message about
REM
changing the mode and then returns to the Output
mode.
3. • To increase the highlighted reference value
shown in the top right corner of the display,
press
It is stored in the permanent memory of the drive
and restored automatically after power switch-
off.
• To decrease the value, press


Adjusting display contrast in the Output mode

Step Action
1. If you are not in the Output mode, press
repeatedly until you get there.
2. • To increase the contrast, press keys
simultaneously.
• To decrease the contrast, press keys
simultaneously.
. The value changes immediately.
EXIT
REM
DIR
LOC
DIR
LOC
DIR
.
EXIT
LOC
DIR
MENU
and
LOC
MENU
and
DIR
Display
30.00rpm
49. 10
Hz
0. 50
A
10. 7
%
MENU
00:00
30.00rpm
49. 10
Hz
0. 50
A
10. 7
%
00:00 MENU
31.00rpm
49. 10
Hz
0. 50
A
10. 7
%
MENU
00:00
Display
30.00rpm
49. 10
Hz
0. 50
A
10. 7
%
00:00 MENU
30.00rpm
49. 10
Hz
0. 50
A
10. 7
%
00:00 MENU