Parameter Groups 10 - ABB ACL30 User Manual

214 Parameters

Parameter groups 10...99

No. Bit/Name/Value/
Range
10
10 START/STOP
10.01 START FUNC
Not sel
In1
3-wire
FBA
IN1 F IN2R
IN1S IN2DIR
Description
Start/stop/direction, slowdown and end limits source
selections.
Selects the source for the start and stop control in
external control.
Note: This parameter cannot be changed while the
drive is running.
No source selected.
Source of the start and stop commands is selected
by parameter 10.02 UP COMMAND. The start/stop is
controlled as follows:
Par. 10.02 Command
0 - > 1
Start
1 - > 0
Stop
Source of the start and stop commands is selected
by parameters 10.02
DOWN COMMAND. The start/stop is controlled as
follows:
Par. 10.02 Par. 10.03
0 - > 1
1
1 - > 0
Any
Any 0
Start and stop control from the source selected by
parameter 72.04 FB CW USED.
The source selected by
forward start signal, the source selected by
DOWN COMMAND is the reverse start signal.
Par. 10.02 Par. 10.03
0 0
1 0
0 1
1 1
The source selected by
start signal (0 = stop, 1 = start), the source selected
by 10.03 DOWN COMMAND is the direction signal
(0 = forward, 1 = reverse).
UP COMMAND and
Command
Start
Stop
Stop
10.02 UP COMMAND is the
Command
Stop
Start
forward
Start
reverse
Stop
10.02 UP COMMAND is the
Def/Type
FbEq
(16b/32b)
IN1 F IN2R/
enum
0
1
2
10.03
3
4
10.03
5