Output Mode; Changing The Direction Of Motor Rotation In Output Mode - ABB ACL30 User Manual

Output mode

In the Output mode, you can:
• monitor actual values of up to three signals
• change the direction of the motor rotation
• set the speed reference
• adjust the display contrast
• start, stop, change the direction and switch between local and remote control.
You get to the Output mode by pressing
The top right corner of the display shows the
reference value. The center can be configured to
show up to three signal values or bar graphs; see
page 95 for instructions on selecting and modifying
the monitored signals.


Changing the direction of motor rotation in Output mode

Step Action
1. If you are not in the Output mode, press
repeatedly until you get there.
2. If the drive is in remote control (REM shown on the
status line), switch to local control by pressing
LOC
. The display briefly shows a message about
REM
changing the mode and then returns to the Output
mode.
3. To change the direction from forward (
the status line) to reverse (
line), or vice versa, press
EXIT
repeatedly.
EXIT
shown on
shown on the status
DIR
.
Using the control panel 95
LOC
49. 10
0. 50
10.
DIR 00:00
Display
30.00rpm
REM
49. 10
0. 50
10.
DIR 00:00
LOC 30.00rpm
49. 10
0. 50
10.
DIR 00:00
30.00rpm
Hz
A
7
%
MENU
Hz
A
7
%
MENU
Hz
A
7
%
MENU