Diagnostics; Beaconing(Stand-Up Adapters) - Brocade Communications Systems CNA 1010 Troubleshooting Manual

Diagnostics

Diagnostics, available through BCU commands and HCM, evaluate the integrity of adapter
hardware and end-to-end connectivity in the fabric. All of these diagnostics can be used while the
system is running.
NOTE
Be sure to disable the port before running any type of port diagnostics.
NOTE
It is advisable to not perform other operations on the adapter while running HCM or BCU diagnostics.
Beaconing
Initiate beaconing on a specific adapter port to flash the port LEDs and make it easier to locate the
adapter in an equipment room.
Initiate link beaconing to flash the LEDs on a specific adapter port and the LEDs on a connected
switch port to verify the connection between adapter and switch. When you initiate link beaconing,
commands are sent to the other side of the link. When the remote port receives these commands,
that port's LEDs flash. The remote port sends a command back to the originating port. When that
port receives this command, the port's LEDs flash.
NOTE
To initiate link beaconing, this feature must be available on the connected switch.
Toggle beaconing on and off and set beaconing duration using the BCU or HCM.
Enabling beaconing through BCU
Use the diag --beacon command to enable beaconing for a specific adapter port and end-to-end
beaconing.
diag --beacon <port_id> -e <on | off> [<duration>]
where:
port_id
-e
duration
Use the fcdiag --linkbeacon command to enable link beaconing.
fcdiag --linkbeacon <portid> {on | off} [<duration>]
where:
Brocade Adapters Troubleshooting Guide
53-1001582-01
ID of the port for which you want to enable beaconing. This could be the
PWWN, port hardware path, or user-specified port name. This could also be
the adapter-index/port-index. For example, to specify adapter 1, port 1, you
would use 1/1 as the port identification.
End-to-end beaconing.
Length of time between blinks.
3

Diagnostics

73