Displaying Fcoe Port Properties; Displaying Remote Port Properties - Brocade Communications Systems CNA 1010 Troubleshooting Manual

•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•

Displaying FCoE port properties

To display the HCM FCoE Port Properties panel, use these steps.
1. Select an FCoE port in the device tree.
2. Click the Properties tab in the right pane.

Displaying remote port properties

Use the HCM Remote Port Properties panel to display properties that are associated with the
remote port, such as WWN, node WWN, port name, Fibre Channel address, frame data field size,
online or offline state, role (such as target or initiator), remote device information, QoS priority, QoS
flow, and target ID. Display this properties panel using the following steps.
1. From the device tree, select a remote port.
2. Click the Remote Port Properties tab in the right panel.
Brocade Adapters Troubleshooting Guide
53-1001582-01
Supported class
FC frame size
Maximum transmission unit (MTU)
Target rate limiting (TRL) enabled or disabled status
Default rate limit
Beaconing status
Fibre Channel Initialization Protocol (FCIP) online or offline state
Local (factory) port MAC address
Fibre Channel address
Priority group ID (PGID)
Queue depth
Interrupt control delay
Bandwidth percentage for priority group
MAC address for FCoE forwarder
Fabric WWN
Fibre Channel map ID
FCoE forwarder writing or nonwriting mode
Maximum speed supported
Port operating topology
Authentication status, algorithm, group, and error status
If it is a target port, two tabs display in the right pane: Properties and LUNs.
Collecting port data
3
85