Brocade Communications Systems CNA 1010 Troubleshooting Manual page 121

TABLE 13
Driver event messages (continued)
Message
Base port link is disabled: Hardware
Address = [Base port MAC].
Storage Driver Events
Authentication enabled for base port:
WWN = [Base port WWN].
Authentication disabled for base
port: WWN = [Base port WWN].
Fabric name changed for base port:
WWN = [Base port WWN].
Logical port WWN: [logical port
WWN], Role: [initiator, target, IPFC
mode etc.] is deleted.
Logical port online: WWN = [logical
port WWN], Role: [initiator, target,
IPFC mode etc.].
Logical port taken offline: WWN =
WWN = [logical port WWN], Role:
[initiator, target, IPFC mode etc.].
Logical port lost fabric connectivity:
WWN = [logical port WWN], Role:
[initiator, target, IPFC mode etc.].
New logical port created: WWN =
[logical port WWN], Role = [initiator,
target, IPFC mode etc.].
New virtual port created using
proprietary interface: WWN = [logical
port WWN], Role: [initiator, target,
IPFC mode etc.].
New virtual port created using
standard interface: WWN = [logical
port WWN], Role: [initiator, target,
IPFC mode etc.].
QOS priority changed to [New QOS
flow ID]: RPWWN = [Remote port
WWN] and LPWWN = [Logical port
WWN].
QOS flow ID changed to [New QOS
flow ID]: RPWWN = [Remote port
WWN] and LPWWN = [Logical port
WWN].
Remote port (WWN = [remote port
WWN] online for logical port (WWN =
[logical port WWN]).
Brocade Adapters Troubleshooting Guide
53-1001582-01
Severity Event Type
Warning Network driver
Information Storage driver
Information Storage driver
Warning Storage driver
Information Storage driver
Information Storage driver
Information Storage driver
Error Storage driver
Information Storage driver
Information Storage driver
Information Storage driver
Information Storage driver
Information Storage driver
Information Storage driver
Adapter driver event messages
Category Sub Cause
Category
10 Disabled Ethernet port
(EthPort) disabled by the
user.
8 (AUDIT) Enabled Authentication
enabled by user
command.
8 (AUDIT) Disabled Authentication
disabled by user
command.
2 (PORT) Changed Fabric name
changed for base
port.
3 (LPORT) Deleted Logical port
deleted.
3 (LPORT) Online Logical port (base
or logical) logged
into fabric.
3 (LPORT) Offline Logical port (base
or logical) logged
out of fabric.
3 (LPORT) Offline Logical port (base
or logical) lost fabric
connectivity.
3 (LPORT) Created New logical port
created.
3 (LPORT) Created. New virtual port
created.
3 (LPORT) Created New virtual port
created.
4 (RPORT) Changed QOS priority
changed.
4 (RPORT) Changed QOS flow ID
changed.
4 (RPORT) Online Login nexus
established with
remote port.
A
Action
No action
required.
No action
required.
No action
required.
No action
required.
No action
required.
No action
required.
No action
required.
Check switch and
adapter
configuration.
No action
required.
No action
required.
No action
required.
No action
required.
No action
required.
No action
required.
101