Memories; Select Fader Page; Memory Bump Modes; Clear Output From Memory Faders - ETC SmartFade User Manual

Memories

Memories are played back from the faders in MEMS mode. In each of the 12 fader pages
the buttons with memories stored will light up dimmed in red when a page is selected. When
the fader is contributing to the output, the button will light up in full.
S e l e c t F a d e r P a g e
If a fader is above zero when a different page is selected, it will not be updated to the
content of the new page until it is brought to zero. Press MEMS twice within 1 second to
select page 1 quickly.
Action

Select fader page

M e m or y B u m p M o d e s
The content of memory faders can be bumped to the level of the BUMPS fader in two ways.
This is controlled with the SOLO button.
SOLO
• OFF = The level generated by pressing a bump button adds into the live output.
• ON = The level generated by pressing a bump button replaces the current output.
C l e a r O u t p u t f r o m M e m or y F a d e r s
Action
Clear output from Memory
Faders
5
Playback
Console
(Held)
MEMS
Console
and
CLEAR
MEMS
Feedback
As long as the button is held, the current fader
page is indicated with a lit bump 1-12. Bumps
for pages with recorded information will blink.
To select a new page, press bump 1-12 and
let go of the MEMS button.
Feedback
All memory faders will be set to zero.
57