Copy A Sequence; Run Modes - ETC SmartFade User Manual

C o p y a S e q u e n c e
Action
1. Activate Copy mode
2. Select source sequence
(change page if neces-
sary).
3. Select target
R u n M o d e s
There are three run modes for a Sequence: Manual, One Shot and Loop (default). The
Stack run mode is determined by the wait times recorded in the Stack steps, if a non-zero
wait time is recorded on the last step the Stack will loop back to step 1. Run modes are set
from the Sequences menu.
Step 1:
Step 2:
Step 3:
Step 4:
Menu choice
Loop
Manual
OneShot
Step 5:
4
Edit
Console
COPY
...
21
...
45
...
21
...
45
Open the Sequences menu:
Menu>[Sequences]
Use the wheel to select Sequence (1-24).
Press (MENU) to confirm.
Use the wheel to select Run Mode.
Press (MENU) to confirm.
Use the wheel to select run mode: OneShot, Manual or Loop.
Console
Wheel
Wheel
Wheel
Press (MENU) to confirm. Continue from Step 2 with another Sequence or exit
the menus.
Feedback
This button lights up. All buttons with content
will blink at full (press CLEAR to exit).
or When this button is pressed, all possible tar-
24
gets for this copy operation will blink. Empty
ones blink at full, occupied ones are dimmed.
48
or As soon as the button is pressed, the source
24
sequence is recorded. The console will auto-
matically return to it's previous fader mode.
48
Feedback
The Sequence will loop from the last step
back to the first, endlessly.
Sequences in this mode use the bump button
to advance to the next step.
Runs sequences through one full cycle only.
The seq will stop and hold the last step. To
prevent the last step persisting on stage
record it as a blackout by using an empty
memory.
51