Record A Memory And Stack Step - ETC SmartFade User Manual

R e c o r d a M e m o r y a n d S t a c k s t e p
It's possible to set up and record a memory state as a step of the Stack at the same time.
Action
1. Activate record
sequence
2. Choose Stack
2.5 If the Stack exists...
3. If desired, set the times
for this step
4. Create a new memory &
step
5. Select a source for this
step
6. End recording
3
Program
Console
REC
SEQ
STACK
Wheel
Wheel
REC
MEM
... or
1 24
...
1 48
REC
SEQ
Feedback
All buttons that can record in this mode will
blink at full in yellow (press CLEAR to exit).
The moment the STACK button is pressed,
the button will light up in full. Now all bump
buttons can be stored as steps, and blink at
full in each fader mode.
If this display is shown:
Choose Erase & Make New or Append To
Existing with the wheel and press (MENU) to
confirm.
Hold REC MEM. While holding, set levels
with the faders in any mode. Release REC
MEM when done.
You can select any memory or intensity
channel. Change fader page if desired.
When a bump button is pressed, that memory
or intensity will be stored as a reference to
this step.
Repeat steps 3-5 until satisfied.
End recording. The console will return to the
fader mode prior to recording this sequence.
Press UNDO to skip the recording.
41