R e c o r d a M a g i c m e m o r y
You can set up and record a random look using the Magic function.
Action
1. Set channels or memory
faders
2. Activate recording
3. Create a Magic look
4. If needed, change page
5. Select fader
Test memory
Press CLEAR four times to clear all intensities. Select MEMS mode. The light in the bump
button of the fader will be dimmed to show that it has content. Move the fader up. The same
look you recorded should appear on stage.
3
Program
Console
Faders
REC
MEM
MAGIC
...
1
12
MEMS
...
or
1
24
...
1
48
Feedback
All channel and memory faders over 0% will
be included in the Magic function. If you are
using memory faders, make sure NEXT is off.
Buttons that can record in this mode will blink
at full. If there is a memory stored already,
this button is dimmed (press CLEAR to exit).
Every time MAGIC is pressed, a new random
look will be created from all channel and
memory faders over 0%.
If needed, hold MEMS and press a bump
button 1-12 to change page.
The moment the bump button is pressed, the
memory is stored and the console will auto-
matically return to it's previous fader mode.
Press UNDO to undo this recording.
33
Need help?
Do you have a question about the SmartFade and is the answer not in the manual?